Training

Location:Training / Embedded Development / FPGA / verilog HDL digital integrated circuit design principles and applications / Design of typical test vectors

You can log in to your eeworld account to continue watching：
Design of typical test vectors
Login

Duration：43 minutes and 57 seconds
Date：2020/08/23

Uploader：桂花蒸

Introduction

keywords： FPGA ASIC Verilog

Verilog HDL digital integrated circuit design principles and applications Cai Jueping and He Xiaochuan lectured by Cai Jueping and Li Zhenrong of Xi'an University of Electronic Science and Technology

You Might Like

Recommended Posts

Hangzhou Dianzi University campus recruitment has begun!: [table=391][tr][td][img=391,28]http://iit.guet.edu.cn/jy/images/index_03_03_03_01.gif[/img][/td][/tr][ tr][td][img=391,33]http://iit.guet.edu.cn /jy/images/index_03_03_03_02.gif[/img][/td][/tr][tr][td; 心仪 Recruitment

WaitCommEvent cannot timeout?: Heroes, after my serial port is opened, when CreateThread(...) //read thread, it seems to die when it runs to WaitCommEvent(..), if (OpenSerialport((char*)(LPCTSTR)strport,57600)) { MessageBox(_T("Ser; zephyry Embedded System

Application of automatic zeroing amplifier in strain tester: Application of Auto-Zero Amplifier in Strain TesterAuthor hope79 IntroductionStrain gauge sensors are widely used, and they use a bridge circuit structure to improve output sensitivity. However, the o; fighting Analog electronics

Problems encountered when designing a counter: I am designing a timing and counting module using CPLD : press reset to clear, press start to start timing, press stop to stop timing and pass the result to the microcontroller . Now I cannot control; woshaogang123 FPGA/CPLD

The principle of I2C bus digital potentiometer and its interface design with single chip microcomputer: Abstract The I2Cbus digital potentiometer is a representative one of the digital potentiometers launched by Xicor Corporation. It integrates many advanced features and attracts much attention from use; rain MCU

VHDL design combinational circuit, modelsim timing simulation midway output is not dynamic: I designed a 3-8 priority encoder using vhdl language. When writing a testbench and using modelsim for sequential simulation, it started normally, but an indeterminate state X appeared in the middle (; 青平果 FPGA/CPLD

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号