l4tmoK0X

C19 handheld console based on ESP32-S3 (compatible with GBC casing)

Overview

This project is a branch of @蕉色幻想's project: A Retro Handheld Game Console Based on the LCSC ESP32S3R8N8 Development Board.
This project aims to achieve a lower cost, therefore cheaper modules are chosen and the header chip is omitted.
Three power supply versions are provided: LDO ASM1117, ME6217C; and DC-DC SY8088.
Regarding materials, please refer to the main project for screen and casing materials; only the modules and power supply (top left corner) differ.
Firmware details are also available in the main project.
This project supports direct USB programming; programming tutorial: Upgrade Device via USB
. This project will not be updated except for hardware bug fixes.

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2026-03-26 02:15:10

[MSP430 Sharing] Implementation of Embedded RTOS on MSP 4 3 0 Microcontroller
Implementation of Embedded RTOS on MSP430 MCU [[i] This post was last edited by Xinhai Baby on 2011-10-12 09:09 [/i]]
stm32l152 nucleo-64
Is there any expert using this chip? Please share with me. I just received the board.
MAX745 Issues
The charging chip is not working properly, the input is 18V and the output is only 2.4V Without further ado, The designed output voltage VBATT should be around 12V. The actual measured VBATT is about
Interface technology materials
Interface technology materials
Seeing the release of iPhone 5, I feel that both Android and WP have great potential.
[i=s]This post was last edited by jameswangsynnex on 2015-3-3 20:00[/i] Perhaps the expectations were too high. The release of iPhone 5 did not make people feel so amazing. I personally think that iPh
TINA-TI simulation issues
In TINA-TI simulation, when simulating the output waveform of an oscillator designed by an op amp, should an oscilloscope be used to view the waveform? Is there also a transient simulation to view the

Datasheet More

Circuits More