MPC574xP functional safety motor control evaluation system

Schematic PCB

S32V2 Vision and Sensor Fusion Low-Cost Evaluation Board

Schematic PCB

KEA128 Green Car Network

Green Car Network Gateway

Schematic PCB

CANable: A small, low-cost, open-source USB-to-CAN adapter based on stm32f0

CANable 2.0 is a small, low-cost, open-source USB to CAN adapter. CANable enumerates as a virtual serial port on your computer and acts as a serial line to CAN bus interface. Using the alternative candleLight firmware, CANable enumerates as a native CAN interface on Linux. CANable 2.0 supports standard CAN and CAN-FD.

The CANable adapter is compatible with ARM-based embedded platforms such as Raspberry Pi, Raspberry Pi Zero, ODROID, BeagleBone, etc., making it ideal for integration into OEM products.

Schematic PCB

BATT-14EMULATOR: 14-cell battery pack to power MC33771 EVB

Schematic PCB

KEA128 and MC10XS3425 lighting controls and electronic switches

How to make a lighting control module using KEA128 and MC10XS3425.

Schematic PCB

MCSXTE2BK142: S32K142 development board for BLDC/PMSM motor control

MTRCKTSPS5604P: 3-phase PMSM development kit using NXP MPC5604P MCU

The NXP MTRCKTSPS5604P development kit is ideal for applications requiring one PMSM motor, such as active suspension or electric powertrain.

Temperature-based heating system designed for automotive engine preheaters

This reference design describes how to design hardware for a temperature-based heating system for a vehicle that has an engine preheater installed, based on ambient temperature and a preordained engine start time. This system can also be used for other purposes, such as turning on a storage heater if the ambient temperature falls below a preordained value.

Choosing the Right 1-Wire Host for Your Embedded Application

This application note presents four categories of 1-Wire master circuits for embedded applications and discusses their capabilities and requirements in relation to available (ie, unused) system resources. The schematics shown here apply to short networks that do not extend beyond the radius of 1 meter and are populated with a small number of 1-Wire slaves. Instructions and a decision worksheet are included to identify the most cost-effective 1-Wire master for the application. The reader should be familiar with the basics of 1-Wire communication and microcontrollers.

MPC5777C BMSS and engine control development board

Schematic PCB

2018 Electronic Competition Question F-Wireless Microphone Amplification System (Xidian University)

Schematic PCB

KITVR5510SKTEVM: VR5510 PMIC programming socket board

CN0275

Complete broadband driver and receiver solution for video over UTP for RGB, YPbPr and more

Schematic PCB

PF8100/PF8200 Customer Evaluation Board

The KITPF8100FRDMEVM and KITPF8200FRDMEVM are customer evaluation boards using the PF8100 and PF8200 power management ICs.

Schematic PCB

FL7740 and FL7760 with Bluetooth wireless dimming control (25 W)

MAX2160 ISDB-T Reference Design

This reference design for the MAX2160 tuner plus demodulator IC demonstrates a compact daughter-board solution for the ISDB-T standard (single-segment). This design converts UHF band signals (470MHz to 770MHz) to a MPEG-2 transport stream. The solution is intended for portable applications, such as cell-phone TVs and PDAs.

CN0311

Wideband low error vector magnitude (EVM) direct conversion transmitter using LO divide-by-2 modulator

Schematic PCB

5 W CCCV AC-DC Adapter GreenPoint® Reference Design

Offline LED Driver for ENERGYSTAR® Residential LED Luminaire Applications - GreenPoint® Reference Design