vJ159EB

Narcissus_AIR001_TSSOP20

Overview

This board is based on the HeZhou air001 chip and is compatible with the PY32F002

minimum system board. Soldering is simple; most components are 0603 packaged
Zener diodes, which don't need to be soldered (the chip is probably less expensive than the Zener diode )
. I didn't solder the 5.1k resistor here; it doesn't affect the A2C Type-C power supply.
[HeZhou air001 official website link]

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2026-03-24 09:02:31

: Schematic diagram of MCU self-study development board version 0.1
: Schematic diagram of MCU self-study development board version 0.1
Newbie's problem with 51 serial port receiving!!!
The 51 serial port receives a set of host computer data every second. The requirement is to control a switch on and off if this set of data is what you want! What I want to ask is how to control a swi
Please help me with the s3c44B0x board problem
I bought a s3c44B0 board some time ago, but it stopped working after a few uses. After powering on, there was no printed information on the serial port. The attached document said that under normal ci
DDK compiled driver does not recognize the self-data type defined in the header file
Two files: try.c try.h source: TARGETNAME=try TARGETPATH=obj TARGETTYPE=DRIVER DRIVERTYPE=WDM INCLUDES=$(XPBASE)inc\ddk\wdm\wxp SOURCES=try.c --------------- DDKXP 2600 uses command line compilation.
【Altera SoC Experience Tour】+ Address Mapping
[i=s]This post was last edited by Bai Ding on 2015-3-29 21:45[/i] How does HPS operate FPGA peripherals? Hardware: Connect the peripherals to the AXI bridge in Qsys Software: Map the physical address
Here we are! Haha!
I got the board I bought in the group purchase! Hey, come here, touch it.

Datasheet More

Circuits More