CN0218

500 V common mode voltage and current monitor

Schematic PCB

CN0219

^{Adopt ADAV801/ADAV803 audio codec to implement S/PDIF and I 2} S interface with SigmaDSP codec

Schematic PCB

CN0224

Quad HDMI input using ADV7612 receiver, fast switching multiplexer with extended temperature range

Schematic PCB

CN0241

High-side current sensing with input overvoltage protection

Schematic PCB

CN0313

EMC COMPLIANT RS-485 Transceiver Protection Circuit

Schematic PCB

CN0368

Reluctance angle and linear position measurement

Schematic PCB

CN0263

Robust video receiver with battery short-circuit protection on input      

Schematic PCB

CN0264: Robust Composite Video Transmission Solution with Output Short-to-Battery Protection for Rearview Cameras and Rear Seat Entertainment Systems

Robust composite video transmission solution with output short-to-battery protection

Schematic PCB

CN0275

Complete broadband driver and receiver solution for video over UTP for RGB, YPbPr and more

Schematic PCB

CN0281

Using ADuC7060/ADuC7061 precision analog microcontroller to build a thermocouple temperature sensor with cold junction compensation based on automotive SENT interface

Schematic PCB

CN0282

USB powered DVI/HDMI to VGA converter (HDMI2VGA) with audio extraction

Schematic PCB

CN0296

Low cost, high performance SOUND BAR system

Schematic PCB

CN0300

12-bit, 4-20mA loop-powered thermocouple measurement system using ARM Cortex-M3

Schematic PCB

CN0197

Li-ion battery pack monitor with integrated signal and power isolation

Schematic PCB

CN0189

Tilt measurements using dual-axis accelerometers

Schematic PCB

CN0156

Amplitude control circuit for AD9834 waveform generator (DDS)

Schematic PCB

Calibration system for pressure transmitter based on AD855X programmable gain amplifier

This reference design addresses this need for pre-factory calibration and provides a complete multi-channel fully automatic calibration system for pressure transmitter calibration before leaving the factory.

Schematic PCB

Lithium battery management system based on AD7280A

This reference design implements the functions required for lithium-ion battery monitoring, including voltage, current and temperature measurement, signal isolation and safety monitoring, and can meet the various needs of lithium battery manufacturers and power system designers.

Schematic PCB

15-channel lithium battery management module

This reference design implements voltage and temperature monitoring of 15 lithium battery cells. While ensuring signal monitoring accuracy, it also provides the architecture of the main monitoring circuit and secondary monitoring circuit to achieve a higher level of system protection. It also provides a modular and scalable board-level architecture. In addition to the main monitoring circuit module, secondary monitoring circuit module, and data interface module, other modules such as active equalization circuits can be expanded to facilitate system prototype development.

Schematic PCB

1/8 brick power module based on ADP1051

The 1/8 brick power module in this reference design is designed based on the 1/8 brick power supply standard defined by the Distributed Power Open Standards Alliance (DOSA). This power module uses an Analog Devices ADP1051 to control the energy conversion from input to output.

Schematic PCB